Drivers B Pillar Rattle
-
- Posts: 19
- Joined: Mon May 14, 2012 2:24 pm
- I drive a: GT 2.0 TDI 170/184
- In: Candy White
- With a: Manual box
Drivers B Pillar Rattle
Anyone experiencing a rather irritating buzz/rattle from just behind their right ear. It isn't there all the time, just on certain road surfaces! It stops if I press firmly against the plastic trim box section covering the upper B pillar. Anyone give me advice on how to remove this trim section so I can maybe felt/gaffa the clips before refitting... or any other advice!? Thanks
- RW1
- Legend
- Posts: 4680
- Joined: Tue Jul 07, 2009 9:06 pm
- I drive a: 1.4 TSI 160
- In: Candy White
- With a: DSG box
Re: Drivers B Pillar Rattle
You won't like this but due the interior side panels interlocking, to remove with minimal risk of cracking the plastics, the whole rear right side set of panels come off. This will give you access to the 2 Torx bolts hidden at the lower joint line of the upper B pillar panel.
I'd try pin the point exactly and address it with some thin sticky felt or a small cut pad from a Velcro hoop pad to stop the movement if possible. There's only the top of the seat belt hanger behind there.
You end up like this (but opposite hand) to get at the two lower Torx Bolts holding the B pillar.
Order:
- Remove rear bench seat
(Keep the rear seat vertical to prevent possible damage to the seat trim.)
– Remove right short parcel shelf support for luggage compartment cover. ( 3 Torx Bolts [Torque: 1.5Nm])
– Remove roof end strip at the rear end of the large roof trim panel. Pops out.
– Remove C-pillar trim round the rear window rear side.
...(1 Torx Bolt behind the Airbag emblem plastic plug [Torque: 1.5Nm], then pops off some plastic peg/body holes)
– Remove side panel trim by the rear right panel (1 Torx Bolt 3.5Nm plus plastic pegging)
– Remove 2 Torx bolts at the bottom of the upper B pillar trim (4.5Nm).
– Pull out the upper B pillar trim from under moulded headliner interlock point.
C.
I'd try pin the point exactly and address it with some thin sticky felt or a small cut pad from a Velcro hoop pad to stop the movement if possible. There's only the top of the seat belt hanger behind there.
You end up like this (but opposite hand) to get at the two lower Torx Bolts holding the B pillar.
Order:
- Remove rear bench seat
(Keep the rear seat vertical to prevent possible damage to the seat trim.)
– Remove right short parcel shelf support for luggage compartment cover. ( 3 Torx Bolts [Torque: 1.5Nm])
– Remove roof end strip at the rear end of the large roof trim panel. Pops out.
– Remove C-pillar trim round the rear window rear side.
...(1 Torx Bolt behind the Airbag emblem plastic plug [Torque: 1.5Nm], then pops off some plastic peg/body holes)
– Remove side panel trim by the rear right panel (1 Torx Bolt 3.5Nm plus plastic pegging)
– Remove 2 Torx bolts at the bottom of the upper B pillar trim (4.5Nm).
– Pull out the upper B pillar trim from under moulded headliner interlock point.
C.
You do not have the required permissions to view the files attached to this post.
Week 43 Build has happened on time! 22 Oct'09 Scirocco is at Check Point 5 in the factory
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
-
- Posts: 19
- Joined: Mon May 14, 2012 2:24 pm
- I drive a: GT 2.0 TDI 170/184
- In: Candy White
- With a: Manual box
Re: Drivers B Pillar Rattle
Thanks very much for that.... Will try more padding and if that doesn't do it I will mention it to the dealer when I go in for service as it's a new car under warranty! They can do all the hard work! 

- RW1
- Legend
- Posts: 4680
- Joined: Tue Jul 07, 2009 9:06 pm
- I drive a: 1.4 TSI 160
- In: Candy White
- With a: DSG box
Re: Drivers B Pillar Rattle
Wise decision! 
C.

C.
Week 43 Build has happened on time! 22 Oct'09 Scirocco is at Check Point 5 in the factory
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
-
- Posts: 182
- Joined: Tue Mar 31, 2009 12:13 pm
- I drive a: GT 2.0 TSI
- In: Candy White
- With a: DSG box
- Location: Glasgae
Vibration from seatbelt
Anyone else experiencing vibrations from inside the rear panel where the seatbelt mechanism is?
Sent from my Nexus 4 using Tapatalk
Sent from my Nexus 4 using Tapatalk
Last edited by RW1 on Tue Jan 01, 2013 5:09 pm, edited 1 time in total.
Reason: Merged....
Reason: Merged....
-
- Posts: 182
- Joined: Tue Mar 31, 2009 12:13 pm
- I drive a: GT 2.0 TSI
- In: Candy White
- With a: DSG box
- Location: Glasgae
Re: Drivers B Pillar Rattle
I stripped my panel down and found that my seatbelt mechanism is the issue, what's the fix?
Sent from my Nexus 4 using Tapatalk
Sent from my Nexus 4 using Tapatalk
- RW1
- Legend
- Posts: 4680
- Joined: Tue Jul 07, 2009 9:06 pm
- I drive a: 1.4 TSI 160
- In: Candy White
- With a: DSG box
Re: Drivers B Pillar Rattle
Internally or knocking against part of the bodywork?
C.
C.
Week 43 Build has happened on time! 22 Oct'09 Scirocco is at Check Point 5 in the factory
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
-
- Posts: 182
- Joined: Tue Mar 31, 2009 12:13 pm
- I drive a: GT 2.0 TSI
- In: Candy White
- With a: DSG box
- Location: Glasgae
Re: Drivers B Pillar Rattle
Its the actual mechanism internally, if you tap it, it rattles.
Sent from my Nexus 4 using Tapatalk
Sent from my Nexus 4 using Tapatalk
- RW1
- Legend
- Posts: 4680
- Joined: Tue Jul 07, 2009 9:06 pm
- I drive a: 1.4 TSI 160
- In: Candy White
- With a: DSG box
Re: Drivers B Pillar Rattle
Given the safety issue, I'd be replacing it as rattles internally. Suggests something is broken.
Either warranty replacement or one from a donnor car.
C.
Either warranty replacement or one from a donnor car.
C.
Week 43 Build has happened on time! 22 Oct'09 Scirocco is at Check Point 5 in the factory
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
23 Oct'09 Now Complete on the dockside, 24 Oct'09 Sailed from Portugal, 27 Oct'09 In the UK,
29 Oct'09 at dealers Driving 4th Nov. Sorted!
-
- Posts: 182
- Joined: Tue Mar 31, 2009 12:13 pm
- I drive a: GT 2.0 TSI
- In: Candy White
- With a: DSG box
- Location: Glasgae
Re: Drivers B Pillar Rattle
Will have to book it in then and get them to fix under warranty
Sent from my Nexus 4 using Tapatalk
Sent from my Nexus 4 using Tapatalk
- Komar
- Posts: 215
- Joined: Sun Feb 13, 2011 3:19 pm
- I drive a: 1.4 TSI 122/125
- In: Candy White
- With a: Manual box
Re: Drivers B Pillar Rattle
I have some sort of vibration too, behind right ear when I hit the bump with rear right wheel........
that plastic is not a good quality I guess

that plastic is not a good quality I guess
