Page 1 of 1
Bixenon
Posted: Mon Jan 25, 2016 5:04 pm
by Chris_r
Hi!finally I decide to change my oem headlights to bixenon so I bought a pair with ballast on!also I bought the bixenon adapters and I installed them to oem.i want to ask where to pin the yellow cables from the bixenon adapters to the bcm?
Re: Bixenon
Posted: Mon Jan 25, 2016 5:49 pm
by blower
The yellow cables from the adapters will be for the high beam shutters. They go to pin 48 and 49 on the gold CECM (BCM) connector.
As you are probably aware you should also have the AFS HID leveller installed for them to be legal in the UK and pass an MOT - however not all MOT test centres check for it (or know how to check it). Having said that without the AFS module wired in you might find they are pointing in the wrong direction (too far down/up etc)
Re: Bixenon
Posted: Mon Jan 25, 2016 10:50 pm
by Chris_r
Thanx for your help!is there a slot on the gold cecm with the mark 48-49?
Re: Bixenon
Posted: Mon Jan 25, 2016 10:57 pm
by blower
Yep, once you remove the connectors shroud you will be able to see the pin numbers (they are on the back side or the face, i can't remember)
As seen in this pic:
courtesy of Bruno Prado
Re: Bixenon
Posted: Mon Jan 25, 2016 11:43 pm
by Chris_r
thanks again!i will try it tomorrow!
Re: Bixenon
Posted: Wed Jan 27, 2016 12:39 pm
by Chris_r
is there any tips how to take out the gold bcm??