What did you do to your Scirocco today?
-
- Posts: 3
- Joined: Sat Dec 05, 2020 1:31 pm
- I drive a: GT 2.0 TSI
- In: Viper Green
- With a: Manual box
Re: What did you do to your Scirocco today?
Mine were a mess, cleaned them up with some fine wire wool and autosol. Not sure if the pic will work or not but these were done about 3 weeks ago.
https://mightytext.net/zN3oR8
https://mightytext.net/zN3oR8
-
- Posts: 2
- Joined: Wed Aug 31, 2022 9:23 am
- I drive a: 1.4 TSI 160
- In: Candy White
- With a: Manual box
Re: What did you do to your Scirocco today?
Hey all,
I got a cat-back stainless quad exit exhaust into 3.5'' tips for the Rocco yesterday, It is insanely loud to be honest, Whopping 120dB
I also put new Interior LED's in
I still have few more things to do
I got a cat-back stainless quad exit exhaust into 3.5'' tips for the Rocco yesterday, It is insanely loud to be honest, Whopping 120dB
I also put new Interior LED's in
I still have few more things to do
-
- Posts: 41
- Joined: Mon Apr 08, 2019 3:47 pm
- I drive a: GT 2.0 TSI
- In: Shadow Blue
- With a: Manual box
Re: What did you do to your Scirocco today?
Search this: GB ACTIVE:Direct Bolt-on Single Gas Strut Bonnet support kit and the last post gives contact details.
-
- Posts: 3
- Joined: Sat May 28, 2022 3:32 pm
- I drive a: GT 2.0 TSI
- In: Candy White
- With a: Manual box
Re: What did you do to your Scirocco today?
-
- Posts: 12
- Joined: Fri Jan 22, 2016 6:21 pm
- I drive a: 1.4 TSI 122/125
- In: Candy White
- With a: Manual box
Re: What did you do to your Scirocco today?
Fitted a full Scorpion system, downpipe, resonatorless centre and back box. Just as well I have no neighbours...
-
- Posts: 1
- Joined: Tue Oct 04, 2022 5:22 pm
- I drive a: 1.4 TSI 160
- In: Pure White
- With a: DSG box
Re: What did you do to your Scirocco today?
1. Replace TCU after replaced Mechatronic because the Mecha that the workshop replaced had a faulty TCU.
2. Replace stock coil pack because there was misfiring to Bar-Tek PQ35
2. Replace stock coil pack because there was misfiring to Bar-Tek PQ35
-
- Posts: 9
- Joined: Thu Nov 03, 2022 9:17 pm
- I drive a: 2.0 TDI 140
- In: Pure White
- With a: Manual box
Re: What did you do to your Scirocco today?
Had a quantum stage one map today who said there crap are u mad it’s like I’ve got double the power no lag at all I must of read old posts must of been crap 10 years ago but my car is flying now and the torque is unbelievable
-
- Posts: 1
- Joined: Sat Nov 19, 2022 11:19 pm
Re: What did you do to your Scirocco today?
Repaired the touchscreen after following an excellent YouTube video . Touchpad came from Hong Kong in less than a week . £13 and good as new . Well impressed. Ordered another as a spare .
-
- Posts: 11
- Joined: Fri Nov 18, 2022 1:27 pm
- I drive a: 1.4 TSI 160
- In: Opal Silver
- With a: Manual box
Re: What did you do to your Scirocco today?
Hello! Im trying retrofitting original scirocco R drls on my scirocco non R. Ive changed bcm to 5k0 937 087 AB and did some coding with vcds (byte 27 bit 2, byte 24 bit 7) and when i turn the switch to auto it turns on for 1sec and turns off. When i turned off the switch it turned on about 3-4 sexs and it turned off. Any ideas?
- megatron-uk
- Posts: 81
- Joined: Mon Apr 10, 2023 11:09 am
- I drive a: GT 2.0 TSI
- In: Indium Grey
- With a: Manual box
Re: What did you do to your Scirocco today?
Re-applied sikaflex sealant to the rear edge of the passenger side R sideskirts, as it had started to come away from the body a little, just in front of the rear arch.
Also looking at trying to track down the source of my rear parking sensor fault (fault since I bought it - even with a new set of sensors - VCDS says there is no power supply to them and no signals returned). I stripped the carpet out of the boot today and found that I have no rear control unit - the loom just goes straight up over the right hand wheelarch, so I'm kinda stumped on what to do next!
Also looking at trying to track down the source of my rear parking sensor fault (fault since I bought it - even with a new set of sensors - VCDS says there is no power supply to them and no signals returned). I stripped the carpet out of the boot today and found that I have no rear control unit - the loom just goes straight up over the right hand wheelarch, so I'm kinda stumped on what to do next!