Page 1 of 1

What would you do first ?

Posted: Sat Nov 23, 2019 7:21 am
by The Reaper
a few days ago I picked up a 2009 2.0 tsi manual and would like to check things are functioning to the best of their ability. I would just like to make sure that no area around the engine has been left untouched for a few years as if they have then they may well need cleaning/greasing/oiling/changing.
So I'm thinking along the lines of egr clean/blank, maf clean, throttle body clean etc etc.

A bit about the cars info...

2.0 tsi manual
Stage 2 remap (superchips bluefin)
Ram air intake
Forge blow of valve
Decat
Exhaust resonator delete

I have posted a question about the car stuttering a bit when I'm accelerator hard from around 80mph and between 3.5-4K revs.
So I'm trying to eliminate any possible causes .

What would you do to make sure everything is functioning fully ?

Thanks

Re: What would you do first ?

Posted: Sat Nov 23, 2019 9:16 am
by Zanic L3
I would first make sure that the chain and the tensioner have been upgraded

Re: What would you do first ?

Posted: Sat Nov 23, 2019 11:42 am
by The Reaper
He has said that it's been revised as it's a 2010 model on a 2009 plate. Don't know how much truth is in this

Re: What would you do first ?

Posted: Sat Nov 23, 2019 4:01 pm
by Zanic L3
The Reaper wrote:He has said that it's been revised as it's a 2010 model on a 2009 plate. Don't know how much truth is in this
It was only fixed from mid(?) 2012 and onwards

Re: What would you do first ?

Posted: Sun Nov 24, 2019 1:06 pm
by The Reaper
Yes that's what I've heard aswell. It would be good to find a definitive answer

Re: What would you do first ?

Posted: Sun Nov 24, 2019 10:06 pm
by Zanic L3
The Reaper wrote:Yes that's what I've heard aswell. It would be good to find a definitive answer
I would call the previous owner and ask him if it's done or not...

Re: What would you do first ?

Posted: Mon Nov 25, 2019 2:15 pm
by Paradox1
Zanic L3 wrote:
The Reaper wrote:Yes that's what I've heard aswell. It would be good to find a definitive answer
I would call the previous owner and ask him if it's done or not...
Or check

Get a garage to check the Part number on the tensioner, I think you can see it if you remove the chain over.

If your unsure, id get it changed for peace of mind

Re: What would you do first ?

Posted: Mon Nov 25, 2019 8:22 pm
by Alien_IROC
I can confirm the chain tensioner from mid 2012 are the last revised from VW.
My 2010 need to do the complete chain distribution! A lot of money in VW Service.