Scirocco Central

Mine is set to mph and Uk gallons.


Sent from my iPhone using Tapatalk

How to using Carista

https://youtu.be/bUNrDLtZ9A0


Sent from my iPhone using Tapatalk

I would think yes.[emoji106]


Sent from my iPhone using Tapatalk

You need to first change the country designation using VCDS or Carista. I changed mine to Australia. Then you can change it to MPH on the MFD


Sent from my iPhone using Tapatalk

Good result [emoji41][emoji106]


Sent from my iPhone using Tapatalk

Like I said. It was not a case of being reliable. It was how much of the correct light you as the driver will need to safely see at night.

They look fantastic but serve no use. It’s the wrong kind of light.


Sent from my iPhone using Tapatalk

I have tried these in other cars. You will find they look great cosmetically but at night they are dangerously poor at giving out light.

I personally would not touch them.


Sent from my iPhone using Tapatalk

It’s not normally the belt that fails. It the idler pulley bearings or water pump that go then causing belt failure. Get a few indie quotes then ask the main dealer to price match. I did this on my last car Audi A5 which they normally charge £750. Got them to match a local indie (must be genuine par...

Get DCC turned off using VCDS.

Also can you feedback the difference in ride quality once you have replaced them?

Cheers

Sent from my iPhone using Tapatalk

No I have not and for the price and risk you may as well buy from TPS and know you will not have any issues.


Sent from my iPhone using Tapatalk

Thanks for the tip. Rear knocking has plagued many sciroccos. Do you have a photo which might be helpful?


Sent from my iPhone using Tapatalk

Yes it is. I unbolted my seat and moved it to the rear without unplugging it as there are cut outs in the carpet. I ran it under the centre tunnel (very tight to access but can be done). There was plenty of slack left and it was neatly done.


Sent from my iPhone using Tapatalk

Have you configured it with VCDS? Which stereo did you have originally and what have you installed. If you fit the original; do you have sound?


Sent from my iPhone using Tapatalk

So on June 8 2020 I replaced my callipers with new units along with 312mm Pagid discs and pads both from ECP. Everything on my from set up was new including the wishbone, ball joint, drop links and shocks. After 1000 miles of careful bedding in and just over six weeks; I noticed vibration after the ...

So long as it’s connected to the correct pins yes.


Sent from my iPhone using Tapatalk

It should be straight forward. Make sure you fit the microphone that should come with the Bluetooth module harness.

It may need to be enabled via VCDS for the can gateway to recognise it. Plug it in and go from there.


Sent from my iPhone using Tapatalk

Should be 3C0412521B
level sensor with poles
left


Sent from my iPhone using Tapatalk

I’m in Malpas near Chester. I home on leave all week


Sent from my iPhone using Tapatalk

Open Module 76 – Park Assist: Electronics 1 | 76 - Park Assist Then select Coding – 07 and enable Bit 4 of Byte 0 (with correct labels you can Enable "Optical Illustration active"): Optical Illustration Active Then goto Byte 2 and select the correct Model: Ignore my advise. This was for R...

Open Module 76 – Park Assist:

Electronics 1 | 76 - Park Assist

Then select Coding – 07 and enable Bit 4 of Byte 0 (with correct labels you can Enable "Optical Illustration active"):

Optical Illustration Active

Then goto Byte 2 and select the correct Model: